Emerson InSinkErator CWT-00 Manual Del Propietário página 4

Ocultar thumbs Ver también para InSinkErator CWT-00:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Follow these steps for installing chilled water tank with instant hot/cool water dispenser.
4
FILL TANK & CONNECT POWER
ass Nut
Brass Nut
Ferrule
Ferrule
Brass Insert
a
Property Damage: Before plugging in
chilled water tank, check for leaks in all
water supply connections.
b
Inlet
Electric Shock Hazard: A standard grounded
Outlet
outlet is required under the sink.
Do not use an extension cord set with
the chilled water tank.
The SinkTop Switch
from InSinkErator
electrical outlets, which allows the chilled water tank, hot water dispenser and food
waste disposer to be connected to the same electrical outlet. The chilled water tank
should not be plugged into the SinkTop Switch. The chilled water tank must be connected
directly into the open wall outlet. For more information visit www.insinkerator.com.
6
Turn on the cold water supply.
Depress the cold faucet handle
and hold it until water flows from
the spout.
Allow water to run for at least
60 seconds after water begins to
flow from faucet.
Depress the hot water handle until
water flows smoothly.
Check all connections to ensure they
are tight and that there are no leaks.
Plug in chilled water tank
and hot water dipenser tank.
Prior to drinking water from the chilled
water tank, run the water for at least 5
minutes to flush lines.
Allow up to 60 minutes for
water to reach target temperature.
Gurgling or hissing is normal
during the initial cycle.
conveniently switches power between two
®
The instructions on pages 7-9 will guide you through the
installation of the InSinkErator C1100 Cold Only Faucet
and your Chilled Water Tank.
Follow these steps for installing chilled water tank with a cold only faucet.
1
PREPARATION
a
< 18"
Property Damage: Do not place objects
on top of chilled water tank which
could obstruct the fan.
OVERVIEW OF A TYPICAL INSTALLATION with Cold Only Faucet
Cold Only Faucet
Copper Tubing
Blue Tubing
White Tubing
Filter
Chilled
Water
Tank
InSinkErator C1100
Cold Only Faucet
Turn off water supply.
Identify the undersink location for
the chilled water tank.
For best performance, allow for a
minimum 2" space around the sides
and top of the chilled water tank.
The chilled water tank will require
a minimum footprint of 15" wide
by 11" deep.
Ensure that there is a minimum of
18" vertical clearance for the chilled
water tank.
Shown with optional filtration
Food
Waste
Disposer
Air-Activated
SinkTop Switch
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Insinkerator c1100

Tabla de contenido