Sequencer Modes; Project Mode; Pattern Mode - Korg SQ-64 Manual Del Usuario

SQ-64 Owner's Manual

Sequencer modes

Project mode

Press the PROJECTS button to enter project mode and display the
projects on the 64 pads.
Project load mode
This mode is enabled immediately after you enter project
mode. From the 64 pads, press any pad to load a project.
TIP Pressing the 64 pads while holding down the PROJECTS button
displays the project names.
TIP The pad of the currently selected project lights up.
Project save mode
Turn the PARAM1 knob to select project save mode. (The
current project number lights up.) Press the pad where you
want to save the current project. Then, press the BAR button
1 to save, or press the BAR button 4 to cancel.
Note Before saving, the project name can be changed by using the
PARAM2 and PARAM3 knobs.
Project init mode
Turn the PARAM1 knob to select project init mode. Press
any pad to display the confirmation screen. Press one of
the BAR buttons 1 to 4 to select an operation. Press the
BAR button 1 to initialize the saved project, press the BAR
button 2 to initialize the current project, or press the BAR
button 3 to initialize both. Press the BAR button 4 to cancel
the operation.
TIP To cancel the operation, wait a moment or press another pad.

Pattern mode

The sequence data stored in each track is called "pattern". Press
the PATTERNS button to enter pattern mode and display the
available patterns for each track on the 64 pads.
Pattern select mode
This mode is enabled immediately after you enter pattern
mode. Pressing the 64 pads while holding down the
PATTERNS button displays the pattern name.
TIP The pad of the pattern currently selected lights up.
From the 64 pads, press any pad to load a pattern.
TIP Turn the PARAM2 knob to set the timing to move to the selected
pattern.
Pattern copy mode
Turn the PARAM1 knob to select pattern save mode. (The
current pattern number lights up.) Select the pad where
you want to copy the current pattern. Then press the BAR
button 1 to copy, or press the BAR button 4 to cancel.
TIP Pressing any pad while holding down the PATTERNS button
changes the copy source.
Note Before saving, you can change the pattern name by using the
PARAM2 and PARAM3 knobs.
Pattern clear mode
Turn the PARAM1 knob to select pattern clear mode. Press
the pad you want to clear. Then press the BAR button 1 to
clear, or the BAR button 4 to cancel.
TIP You can undo the operation by pressing the same pad again
immediately after initialization.
15