Inserting The Batteries; Installing The Memory Card - MINOX DTC 600 Manual De Instrucciones

1st function "OFF":
main switch is switched to the left
2nd function "SET UP":
main switch in middle position
3rd function "ON":
main switch is switched to the right
The battery compartment (15) is located in the right side
(back) of the folded out camera.
On the bottom of the camera there are additional ports
for:
- external power supply (12)
- USB (13)
To close the camera body proceed as follows:
1. Place your DTC 600 on a flat surface in front of you.
2. Fold over the front camera body to the right hand
side.
3. Fold up the lock (5) on the right side.
4. Slide down the lock on the right hand side of the
camera body.
26

Inserting the batteries

Your DTC 600 camera is designed for alkaline, lithium or
nickel-metal hydride (NiMH) AA batteries. To insert the
batteries open your camera, insert 10 x 1.5 Volt AA bat-
teries as instructed in the battery compartment (15). Pay
attention to the correct insertion direction/polarity
(+/-).
Checking the battery status
Switch the DTC 600 into "SET UP" mode (main switch
middle position). In the upper left of the LCD screen
the battery status is displayed via the battery symbol.
Note: You can prolong battery life by producing
smaller video segments.

Installing the memory card

To store photos and videos you need a memory card (SD/
SDHC card). Your DTC 600 camera works with memory
cards of up to 32 GB in size.
Installing the memory card
Insert the memory card into the slot (9) with the marked
side facing you. Make sure that the SD card slide is not
in closed position. Switch your DTC 600 into "SET UP"