Technical Data - Carat CARACOUP Manual De Instrucciones

GB

Technical data

Voltage:
Power absorbed:
Admissible working conditions:
INTERMITTENT - S3-SERVICE
Rotation speed:
Capacitor:
IP Degree:
Thermal Circuit Breaker:
Tool:
CONTINUOUS CROWN DIAMOND BLADE
Diameter:
Centre hole:
Max. cutting depth:
40 mm - cut 90° / 40 mm cut 45°
Water recirculation pump:
Recommended use:
CERAMIC, SINGLE-FIRED CERAMIC, COTTO
AND MARBLE (max. thickness 20 mm.)
Weight:
Max. cut length:
Tank capacity:
230V 50Hz~
1000W
30 sec. under load running
30 sec. repose
2800 min
18 µF
170°C
WET CUTTING
Ø200 mm
25,4 mm
P0 230V 50/60Hz
BUK2650000 BUK2900000
34 Kg 39 Kg
600 mm 900 mm
25 L
1. Use
CAUTION !
Before using the machine read the safety
instruction chapter carefully.
All machines have been thoroughly tested and
checked before leaving our factory.
Carat Centrale B.V. works for a continuous
development of the machines the company
manufactures, therefore the company reserves
the right to modify its models. No rights can be
therefore claimed as far as data and pictures of
-1 this manual are concerned.
The CARACOUP diamond blade cutting machine is
suitable for cutting any type of ceramic material. It
44
can also be used to carry out 90° as well as 45° cuts
(jolly). The cutting depth and inclination can both be
adjusted.
2. Precautions
• The manufacturer declines any liability for the
use of any CARACOUP tile cutter with tools
other than the original ones and for the cutting
of materials not indicated in the paragraph
"RECOMMENDED USE".
• The CARACOUP
exclusively according to the ADMISSIBLE
WORKING CONDITIONS indicated in the
paragraph: "TECHNICAL DATA".
• During the cutting phase it is therefore
recommended to interrupt the working cycle as
indicated.
• The CARACOUP was not designed to work
under continuous load.
CAUTION !
Keep in mind the following tips:
• Let the motor slide slowly. Avoid any disk
blocking.
• Make sure that the piece to be cut is duly
leaned against the tile stopper.
• Before any cutting operation make sure that
35 L
the adjustment knobs for cutting inclination
are tightened.
• After some cutting sharpen the disk with a
hone.
During cutting operations dangerous splinters may
come off.
18
is designed
WARNING !
to work