Hoshizaki DIM-30AE Manual De Instrucciones página 4

* Only potable water should be used for this ice
dispenser.
* Water supply pressure should be minimum 0.5
bar and maximum 8 bar. If the pressure exceeds
8 bar, use a pressure reducing valve. Do NOT
throttle back the supply tap.
* A plumbing permit and services of a licensed
plumber may be required in some areas.
* The water supply and drain pipes should not
block the air ventilation slots on the rear panel.
* The ice dispenser drain is gravity flow, so ensure
drain pipe has an adequate pitch or fall.
* Water should drain into an open trap.
) By means of a suitable spanner or wrench,
tighten the /2-3/4 nipple (accessory) into the
Rc1/2 fitting on the rear of the ice dispenser as
indicated. P.T.F.E. tape and/or a suitable sealing
compound should be used to obtain a leak free
joint.
Note: Jointing compounds should be approved
and suitable for potable water use.
2) Attach angled end of white flexible inlet hose
(accessory) to free end of /2-3/4 nipple
ensuring rubber sealing washer is correctly
positioned. Hand tighten sufficiently to provide
leak free joint.
3) Attach the other end of inlet hose to the water
tap, noting washer is correctly positioned before
Inlet Hose
Outlet Hose
Fig. 3
hand tightening as above.
4) Attach grey flexible outlet hose (accessory) to
the R3/4 fitting as indicated, confirming fitment
of rubber washer before finally hand tightening
the joint. This pipe can be cut to length as
necessary to suit position of main drain.
II. OPERATING INSTRUCTIONS
. This ice dispenser is designed to produce
and store edible ice. To keep the ice
dispenser hygienic:
* Keep the Ice Station clean. Clean it
2. The use of any electrical equipment
i n v o l v e s t h e o b s e r v a n c e o f s o m e
fundamental rules. In particular:
* Instances of high humidity and moisture
Water Supply
Inlet Rc/2
* Do not pull the power cord in order to
/2-3/4 Nipple
* To prevent possible electric shock caused
* Appliance must be positioned so that the
Drain Outlet
R3/4 3. All parts are factory-adjusted. Improper
adjustments may result in failure.
4. If the Power Switch is turned off, wait for
at least 5 minutes before restarting the
ice dispenser to prevent damage to the
Compressor.
3
Fig. 4
WARNING
by using a neutral cleaner and rinse
thoroughly.
increase the risk of electrical short
circuits and potential electrical shocks. If
in doubt, disconnect the ice dispenser.
disconnect the ice dispenser from the
feed network.
by accidental contact with the attachment
plug, the ice dispenser must be plugged
in tightly.
plug is accessible.
ENGLISH
Water Supply Tap
Inlet Hose