Hdmi - Andonstar ADSM301 Manual De Instrucciones

* To record videos:
1.Press 'M' shortly to get into the Record mode. Press 'OK' to start recording.
2.Press 'OK' to stop recording.
PS: Press 'Lock&unlock' on the remote to lock the file when it's recording. So the video file won't be covered by
new files when the memory card is full.

◆HDMI

·First, make sure that the monitor connecting to the microscope is literally HDMI monitor. Otherwise it won't
perform as good as we expected.
·Second, connect the microscope to the HDMI monitor, also, connect it to the power supply. Because there is no
built-in battery in the device, so make sure the microscope is always in charging when you use it.
·Third, turn on the microscope and adjust the distance. Then put the object on the table and adjust the focus
controller.
·It won't show anything on it's own screen when it is connected to other equipment. So it's normal that when you
use it as HDMI output, the 5 inch screen keeps being dark.
·You still can take pictures and save them if you have a memory card inside the microscope. But you can't record
videos in this output mode.
FAQ
•Why is there no image on the monitor ?
Please check all the cables connect properly and also make sure the device is switched on.
•Why the image is not clear ?
Please adjust the object distance and the focus controller, check the direction of the LED lights, and make sure the
lens is clean enough.
•Remote doesn't work ?
There is no battery inside of the remote as standard configuration. Please check if there is battery in the remote.
•Why is there no image in playback model ?
Sometimes the video file is too big, the system needs time to process.
•SD card error
Make sure the memory card you use is certified and quality. Format the memory card in the system first, then try
- 10 -