Installation And Use; Safety Instructions; Use - Casselin CSC1 Manual De Instrucciones

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.

5.2 Use

Unpack the hair dryer completely.
- Drill two 6mm diameter holes, aligned and spaced 125mm apart and 1.50 meters high
- Insert the dowels into the holes.
- Screw the plastic part which clips to the hair dryer support in the wall using one of the screws provided in
the top hole.
- Then take the larger screw and screw it into the wall through the hole in the hand dryer support at the
bottom right. Secure the hair dryer support then cover the hole with the available plastic cover.
- Connect the appliance without pressing the switch.
- Take the hair dryer then press the switch to operate it. Test it several times to verify proper operation of
the device.
- The installation of the hair dryer without a wall outlet must be carried out by a qualified professional who
bears full responsibility.
- The installation of the hair dryer in a drawer is prohibited
FLOOR AREA
EN