Publicidad
Idiomas disponibles
Idiomas disponibles
These instructions are part of the Duravit
product and must be read carefully and kept
available at all times.
Target readership and qualifications
The product may only be installed by a qualified
plumber.
Generally accepted engineering practices
should be applied. (In particular, compliance
with ASME A112.18.1 / B125 is recommended)
Explanation of the key words
Addresses practices not
NOTICE
related to physical injury.
Technical data
Operating pressure:
max. 5 bar / 72.5 PSI /
0,5 MPA
Recommended:
3 bar / 43.5 PSI / 0,3 MPa
Test pressure:
10 bar / 145 PSI / 1,0 MPa
1 MPa = 10 bar = 145 PSI
max. 140 °F
Hot water temperature:
This unit meets or exceeds the
following:
• ASME A112.18.1
• CSA B125.1
4
MAL_57171/19.03.2
Safety instructions
Cut and crush injuries
> Wear gloves when installing the product.
Product and/or property damage
> Observe the local installation regulations and
any country-specific standards at all times.
> Equalise pressure differences between cold
and hot water connections.
> Observe the manufacturer's instructions for
installation with continuous flow heaters.
Publicidad
