Before Use - Taurus CUTMASTER COMPACT Manual De Instrucciones

ENGLISH
Meat Slicer
Cutmaster Compact
DESCRIPTION
A ON/OFF button
B Safety button
C Thickness indicator
D Blade
E Cutting guide
F Blade axle
G Sliding carriage shield
H Sliding guard
I Foldable platform
J Shield – pusher
K Thickness regulator
USE AND CARE:
- Fully extend the appliance's power cable before
each use.
- Do not use the appliance if its accessories are
not properly fitted.
- Do not use the appliance if the accessories
attached to it are defective. Replace them
immediately.
- Do not use the appliance if the on/off switch
does not work.
- Do not move the appliance while in use.
- Do not use the appliance if it is tipped up and
do not turn it over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the appli-
ance from operating correctly.
- Use the appliance and its accessories and
tools in accordance with these instructions,
taking into account the working conditions and
the work to be performed. Use the appliance
for operations different from those intended
could result in a hazardous situation.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
- Do not use the appliance with frozen goods or
those containing bones.
INSTRUCTIONS FOR USE

BEFORE USE:

- Make sure that all products' packaging has
been removed.
- Before using the product for the first time, clean
the parts that will come into contact with food in
the manner described in the cleaning section.
- Some parts of the appliance have been lightly
greased. Consequently, the first time the ap-
pliance is used a light smoke may be detected.
After a short time, this smoke will disappear.
USE:
- Extend the cable completely before plugging
it in.
- Place the foldable platform in horizontal posi-
tion.
- Fit the sliding guard into the sliding carriage
shield. (Fig. 1)
- Place the sliding carriage in the platform, fitting
the two flanges located on the bottom of the
carriage in the cavities of the platform and turn
it. (Fig. 2)
- Slide the platform to ensure it is fully engaged.
- Adjust the thickness of the slice by turning the
thickness regulator. The thickness indicator
may be used as a guide.
- Place the food in the sliding carriage and press
it lightly on the cutting guide with the help of the
shield–pusher.
- Connect the appliance to the mains.
- Switch on the appliance. This is done by hold-
ing down the safety button and then switching
on the on/off button.
- Keeping both buttons pressed, move the sliding
carriage forwards and backwards.
- NOTE: if you want to cut hard foods such as
carrots or potatoes do not exceed the cut thick-
ness of 7mm.