Velleman MONCOLHA7PN4 Manual Del Usuario página 4

b. Remote Control
1. power on/off
2. timer
3. P.P picture control
4. decrease
5. mute
6. 16:9/4:3 display
7. AV audio/video
8. increase
9. MENU volume, brightness, colour, contrast
Slide out the battery holder and place 1 x CR2025 battery cell (order code CR2025, incl.) respecting the polarity.
Replace the holder into the remote control.
c. Connections
1. fuse
2. red – 12V
3. black – earthing
4. green – reverse control line
5. white – video 2
6. yellow – video 1
7. red - audio
4. Installation
Before installing the monitor, apply power and test. Contact your dealer if the monitor does not work.
Remove the headrest and place it in an uncluttered work area to ensure that it is not damaged.
Measure the monitor frame and mark the measurements on the back of the headrest.
Use a sharp cutter and cut diagonally into the headrest cover material from corner to corner,
stopping at about 5mm from the corner. Do not cut too deep.
Carefully peel the cover material of the headrest. Now, cut into the foam of the headrest and pre-
fit the frame from time to time. Cut and remove the foam until the frame fits snugly into the
headrest.
Run the power cable from the cable assembly through a hole at the bottom of the headrest. If
possible, conceal the cable using a covering. Run the cable assembly through the frame and
connect all necessary cables to the monitor.
MONCOLHA7PN4
- 4 - VELLEMAN