ALLURIS FMI-220CS Instrucciones De Servicio página 30

8.7. Altering the filter function, only FMI 220 and FMI-230
Using the filter function makes sense for measurements in a dynamic surrounding as well as in the case of
suddenly occurring force variations. There are three types of filter: 3 msec, 20 msec, 150 msec. The 3 msec
response time is recommended for dynamic applications with constantly occuring force variations, vibrations
and so on. An average of all values measured in the response time will be detected. The 150 msec response
time is recommended in the case of unwanted impulsively occurring changes, e.g. in the case of cylinders with
a big piston average, sudden impulses and so on. By choosing the low frequency, these abnormal changes will
be ignored ("filtered").
•
Switch instrument off.
•
Press and hold >>O<<-button.
•
Press I/O-button.
•
Wait until F01 is displayed, then release >>O<<-button.
•
Select function F05 with the PEAK-button.
•
Select desired response time by pressing the MODE-button.
•
Press >>O<<-button to store your settings.
30