Important Safeguards; Warnings; Caution; Prop 65 Warning - Homeright PRO ELECTRIC C800804 Manual De Instrucciones

m CAUTIONS
1. HAZARD: Solvent and paint fumes can explode or ignite,
causing property damage and severe injury, avoid all low
ignition sources such as static electricity sparks and open
flames.
2. HAZARD: Paints, solvents, insecticides, and other materials
may be harmful if inhaled, causing severe nausea, fainting, or
poisoning.
3. HAZARD: Do not hold cord at plug connections to support cord.
Failure to observe may result in electrical shock.

PROP 65 WARNING

Handling the coated electrical wires of this product exposes you
to lead, a chemical known to the State of California to cause birth
defects or other reproductive harm. Wash hands after use.

HAZARD: EXPLOSION OR FIRE

Follow safety instructions and IMPORTANT SAFEGUARDS of paint
manufacturers.
Risk of explosion or fire. Paint, stain and solvent fumes can
explode or ignite, causing property damage and/or severe injury.
Keep area well ventilated. Exhaust and introduce fresh air to keep
fumes from accumulating in work area.
• DO NOT paint in areas where there are ignition sources, static
electricity sparks, pilot lights, heaters, hot objects, cigarettes,
open flames.
• Have fire extinguishing equipment present and in good working
order.
• DO NOT pump combustible paint or other flammable liquids.
Solvent and paint fumes may explode.
• DO NOT use lacquer, lacquer thinner, acetone or other solvents
with low flash points.
• DO NOT use in a confined area. Keep area well ventilated to
keep room free of flammable vapors. Exhaust and fresh air
introduction must be provided. Do not smoke while using or
where spark or flame is present. Avoid all ignition sources such
as static electricity sparks, open flames such as pilot lights, hot
objects, sparks from connecting and disconnecting power cords
and working light switches.
• Hazardous vapors may occur when using paints, solvents or
other paints. Use a respirator or mask whenever there is a
chance vapors may be inhaled.
• DO NOT allow children to play with unit.
• DO NOT repair damaged hose, replace with new one.

HAZARD: HAZARDOUS VAPORS

Paint, stain and solvents, insecticides, varnishes, and other paints
may be harmful if inhaled, causing severe nausea, fainting, or
poisoning.
• Use a mask or respirator when painting when there is a chance
of inhaling vapors.
• Use protective eyewear.
C820429A_MAN_Pro Electric.indd 3

IMPORTANT SAFEGUARDS

PRO ELECTRIC PAINT ROLLER (C800804)

GROUNDING INSTRUCTIONS

The Pro Electric Paint Roller must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of electrical
shock by providing an escape wire for the electric current. This
product is equipped with a cord having a grounding wire with
an appropriate grounding plug. The plug must be plugged into
an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
m WARNING
DANGER - Improper use of the grounding plug can result in a
risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not
connect the grounding wire to either flat blade terminal. The
grounding wire has green insulation, with or without yellow stripes.
Check with a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if in doubt as to
whether the product is properly grounded. Do not modify the plug
provided; if it will not fit the outlet, have the proper outlet installed
by a qualified electrician.
This product is for use on a nominal 120 volt circuit and has a
grounding plug that looks like the plug illustrated in Figure A.
Make sure the product is connected to an outlet having the same
configuration as the plug. A temporary adapter which looks like
the adapter illustrated in Figures B & C, may be used to connect
the plug to a 2-pole receptacle as shown in Figure B if a properly
grounded outlet is not available. The temporary adapter should
only be used until a properly grounded outlet (Figure A) can be
installed by a qualified electrician. The green colored rigid ear lug
or the like extending from the adapter must be connected to a
permanent ground such as a properly grounded outlet box cover.
Whenever the adapter is used, it must be held in place by a metal
screw.
Attention: The temporary adapter shown in sketch B and C is not for use in
Canada. Use only a grounded outlet with this unit.

EXTENSION CORDS

Use only a three-pronged extension cord that has a 3-blade
grounding plug and a 3-slot receptacle that will accept the plug on
the product. Make sure your extension cord is UL/ETL/CSA listed
and is in good condition. When using an extension cord, be sure
to use one heavy enough for the current - for lengths less than
18 feet use a No. 18 AWG. or heavier, for more than 18 feet use
No. 16 AWG. If in doubt use a heavier gauge. An undersized cord
will cause a drop in line voltage resulting in loss of power and
overheating.

STORAGE

Make sure unit is clean and dry before storing. Store in a dry
location. The electrical cord should not be crimped during storage
to prevent damage.
3
Grounding Method
ENGLISH
5/12/10 1:37 PM