Replacing The Lamp - Electrolux EUF2744AOW Manual De Instrucciones

Problem
The compressor does not
start immediately after
pressing the FastFreeze
or after changing the tem‐
perature.
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the
display.
The temperature in the
appliance is too low/too
high.
Door does not open easi‐
ly.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.

7.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Possible cause
The FastFreeze function
is switched on.
This is normal, no error
has occurred.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze or FAST‐
COOL function is switch‐
ed on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The food products tem‐
perature is too high.
The FastFreeze function
is switched on.
You attempted to re-open
the door immediately after
closing.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
ENGLISH
Solution
Refer to "FastFreeze func‐
tion".
The compressor starts after
some time.
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
FASTCOOL manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or FASTCOOL func‐
tion".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Refer to "FastFreeze func‐
tion".
Wait a few seconds between
closing and re-opening of the
door.
11