Technical Data; Description Of The Machine; Safety Instructions - EINHELL FSM 418 Manual De Instrucciones

Anleitung FSM 418 12-sprachig
GB

1. Technical data

Motor rating
Motor speed
A.c. motor
Insulation
Machine actuation
Cable
Thermal motor protection
Cut length
Jolt length
Cut height
Cutting table:
- Dimensions
- Height
- Material
Weight without packaging
Diamond cutting wheel
Sound pressure level
Sound power level
2. Important information
Please read this manual carefully and pay particular
attention to the instructions for use. Use this
information to get to know the machine, its correct
operation and safety regulations before using for the
first time.
Important!
The tile cutting machine is not to be used by children,
by young people under 16 years of age, or by any
persons who are not acquainted with these
instructions.
4
13.11.2001 8:05 Uhr Seite 4

3. Description of the machine

Portable tile cutting machine for small and
400 W S2 10 min.
medium-size tiles.
2800 rpm
Jolt cuts with tilting work top up to 45 degrees.
Water cooling of cutting wheel.
230 V ~ 50 Hz
Rail fence and angle stop.
IP 54
Removable trough as cooling water container. (To
remove: Pull out the trough as far as the stop, lift
by switch
slightly and remove.)
H 07 RN-F 3 x 1
120°C and above
unlimited

4. Safety instructions

unlimited
33 mm
Set up the machine on a level, non-slip floor.
Make sure that the machine does not wobble.
Check that the voltage on the rating plate is the
395 x 385 mm
same as your supply voltage. Only then are you to
178 mm
insert the power plug in the socket-outlet.
Wear safety goggles.
Inox steel
Wear ear-muffs.
10 kg
Wear safety gloves.
Never use cracked diamond cutting wheels.
178 x 25.4 x 2.2
Replace immediately.
70 dB(A)
Never use segmented cutting wheels.
Caution! The cutting wheel runs on after the
80.8 dB(A)
machine is switched off!
Never apply side pressure to the diamond cutting
wheel in order to bring it to a halt.
Always pull out the power plug before changing
the cutting wheel.
Use only suitable diamond cutting wheels:
maximum Ø 180 mm, minimum Ø 150 mm,
hole Ø 25.4 mm, width 2.2 mm.
Important: Note the width of the splitter!
Close the safety hood when you are finished with
your work.
Never leave the machine unattended in rooms
with children.
Keep the machine safe from children.
Always pull out the power plug before examining
the electric motor compartment system.