Programme Selection - Beem MILK-SWIRL Manual De Instrucciones

19
Preparation and Operation

Programme Selection

The On / Off button (4) can be used to switch between the different programmes. The device
has three programmes. The LED ring (5) indicates the selected programme by the colour.
Programme Control lamp
1
Red
2
White
3
Blue
How quickly the milk is heated is dependent on the temperature of the milk that is used
and the programme selected. For the best possible result, we recommend using cold milk
from the fridge for frothing.
To switch between the different programmes, press the On / Off button several times.
Markings in the Milk Jug
The milk jug (6) contains three different markings (PICTURE B):
MAX
Maximum fi ll level for heating without frothing (approx. 230 ml)
MIN
Maximum fi ll level for frothing (approx. 130 ml)
Please Note! The marking between the MIN and MAX marking indicates the maximum fi ll
level if milk is to be frothed (approx. 200 ml).
Preparation
PLEASE NOTE!
• Do not fi ll the milk jug if it is positioned in the base station! Remove the milk jug from
the base station to fi ll it.
Never use the milk jug without milk or with less milk than is needed to reach the MIN
•
marking!
• Never use the milk jug without the lid. Hot milk could spray out during frothing and
heating.
When the device is fi rst used, production-related additives (e. g. grease) may cause a
small amount of smoke and / or an odour to be produced. This is normal and not a
device defect.
Insert
Stirring insert
Frothing spiral
Stirring insert
Stirring insert
Frothing spiral
Intended use
Heating milk
Preparing warm milk froth
Making warm cocoa /
hot chocolate
Making cold cocoa
Preparing cold milk froth
EN