Fig. 6:
If you want to bring the combi-unit into the sitting position, remove the
mattress and attach the 5-point belt (11) and the abdominal support
(12). Always secure your child with the 5-point belt. Close the belt by
joining the two buckles (13) at the belt straps (left and right) and
inserting them into the belt buckle (14) until you hear a click. To open
it, simply press the button in the middle of the belt buckle (14). The
straps can be adjusted to the size of your child with the tensioning
system and the height lock. To make it easier to get in, you can attach
the straps to the loops (15) on the left and right. The bumper bar (12)
is attached to the frame on the left and right under the swivel joint.
Position it and close the locks (a). *To make it easier for your child to
get on, open only one lock and swing the bar to the side.
Fig. 7:
To swivel the combi-unit to the two different positions, operate the
sliding buttons (16) and move it to the desired position.
ATTENTION: Only swivel the combi-unit without a child! You can use the
combi-unit with or without an additional footplate in the sitting
position.
Fig. 8:
Attach the additional foot board (17) by engaging the telescopic rod
in the two slots provided in the frame. At the back of the footrest you
can press the two sliders of the telescopic pole together, this makes it
easier to attach and is necessary to remove the footrest. Finally, fasten
the cover to the footplate with the press studs (a).
Remove the markings on the frame, they only serve to indicate this
position.
Fig. 9:
You can pull an integrated sun visor (18) out of the canopy. For better
ventilation of the combi-unit, you can provide fresh air at the head
end of the canopy and tub by opening the zippers (19). Fold the open
covers upwards. Two magnets at the foot end secure the open flap in
this position. If you do not fully open the zipper of the foot cover, you
can fold it to the side.