Speaker Setup; Bridge Mode - Phonic POWERPOD 630RW Manual Del Usuario

9. Monitor Outputs
These 1/4" TS outputs are the final output from the Monitor
send mix. This feed may be used to connect to an amplifier and
speaker. Feeding the output from the Monitor out to an amplifier
(and possibly an equalizer) and then to a floor monitor speaker
allows artists to monitor their own instruments or vocals whilst
performing, or an engineer to monitor the mix.
10. Main Outputs
These jacks will output the final stereo line level signal sent from the
main mix. The primary purpose of these jacks is to send the Main
output to external devices that may run in parallel with the mixer.
This may include additional power amplifiers, mixers, PA systems,
as well as a wide range of other possible signal processors.
9
10
Rear Panel
11. Speaker Outputs
These jacks are used to connect to speakers, fed from the internal
power amp. They consist of 1/4" Phone Jacks. The Amp Select
switch determines the operation of these jacks. If the Amp Select
switch is set to "Main 1-2" or "Main / Moni" a single speaker with a
4 to 8 ohm load can be connected to jack A on both the Main 1 and
Main 2 Speaker Outputs. You can also connect two speakers with
impedances between 8 and 16 ohms to both jacks A and B of the
Main 1 and Main 2 Speaker Outputs.
When using Bridge Mono mode, use the Speaker Output labeled
"Bridge" only to connect a Speaker with a loading between 8 and
16 ohms. Refer to the Speaker set up chart to the right for a more
detailed indication of how to connect speakers.
NB. Due to the fact that the signal has been processed by the power amp,
these ports should be used in conjunction with passive speakers only to
avoid damaging any other equipment.
11
POWERPOD 630RW
SPE A K ER SETUP
One Speaker Per Channel
4Ω to 8Ω
Two Speakers Per Channel
8Ω to 16Ω 8Ω to 16Ω

Bridge Mode

NOT
USED
Using speakers with an incorrect loading can not only cause
distortion, but also irreversible damage to the powered mixer.
Please ensure the loadings of your speakers are consistent
with those shown above.
NOT
USED
4Ω to 8Ω
NOT
USED
8Ω to 16Ω 8Ω to 16Ω
NOT
USED
8Ω to 16Ω
3