Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - Toolson PRO-AS 14,4 Manual De Instrucciones

Anleitung PRO_AS_14_4_SPK7:_
6.8 LED lamp (Fig. 8)
The LED lamp (10) can be used in poor lighting
conditions to illuminate the area where you want to
drill or screw. You can switch on the LED lamp by
pressing the button (11). Pressing the button (11)
again will switch off the LED lamp (10).
6.9 Changing the tool (Fig. 9)
Important! Set the changeover switch (3) to its
centre position whenever you carry out any work (for
example changing the tool, maintenance work, etc.)
on the cordless screwdriver.
The cordless screwdriver is fitted with a quick-
action chuck (9) with an automatic spindle stop.
Open the chuck (9). The chuck opening (a) must
be large enough to hold the tool (drill bit or
screwdriver bit).
Select the suitable tool. Push the tool as far as
possible into the chuck opening (a).
Tighten the chuck (9) and then check that the
tool is secure.
6.10 Magnetic screw holder (Fig. 10/Item 12)
Screws can be placed in easy reach on the magnetic
screw holder (12).
6.11 Removing / fitting the cover (Fig. 11/Item 13)
Turn the cover (13) as shown in Figure 11 and
remove it.
Fit the cover (13) by following the above in reverse.
Important!
The machine must not be used without the cover
/ bit magazine.
6.12 Bit magazine (Fig. 12/Item 14)
When you have removed the cover (13), you can fit
the bit magazine (14) on the cordless screwdriver.
Place the bit magazine (14) on the cordless
screwdriver and secure it by turning it clockwise.
To remove the bits, you must press the knob (a) and
turn the housing (b).
6.13 Screwdriving
We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matches
the screw in shape and size. Set the torque, as
described elsewhere in these operating instructions,
to suit the size of screw.
11.03.2009 7:14 Uhr Seite 13
7. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
13