Installation Steps - Milltronics RBSS Manual De Instrucciones

Installation Steps

1. Measure the distance between the inside of the conveyor stringers, and then cut
the 24mm (1") cross bar to the measured length
2. Orient the Return Belt Speed Sensor as shown in the Location diagram on page 2.
3. Slide the cross bar through the hole on the end of the Return Belt Speed Sensor, and
then slide one 24mm (1") washer onto either end of the cross bar.
4. Position the assembly so the sensor wheel rides in the middle of the return belt.
5. Make sure there is 3mm (1/8") clearance between the sides of the sensor and the
washers, and then tack-weld the washers to the cross bar.
6. Tack-weld one end of the cross bar to one stringer.
7. Square the entire assembly with the return belt so the wheel will ride straight.
8. Tack-weld the other end of the cross bar to the opposite stringer, making sure the
assembly remains square with the belt.
stringer
tack-weld
RBSS
return belt
9. Run the belt to check that the wheel is riding straight on the belt and is not pulling to
either side. If necessary, break one weld and pivot the entire assembly until the
wheel runs true.
10. Connect cable wires as indicated below:
• RED  excitation
• WHITE  signal
• BLACK  common
7ML19981GX61
washer
RBSS – INSTRUCTION MANUAL
tack-weld
cross-bar
Page 3