Safety Warnings; Product Installation - Fracarro SIG7622 Instrucciones De Uso

Environmental conditions: This equipment is designed to be installed indoors. Do not install it in places
where corrosive vapors or critical environmental conditions are present nor in dangerous areas.
Characteristics of the installation room: The unit must be installed by authorized and qualified personnel in
accordance with local safety regulations.
The product must not be exposed to dripping or splashing and for this reason the product must be installed in a
dry location, protected from weather conditions and have the following characteristics:
• the environment must not be classified as a high risk of fire;
• there must not be high concentration of suspended particles;
• the system must be placed in a private room protected by possible intrusions and accessible to the
maintenance personnel;
• the system must not be exposed to ultraviolet rays;
• do not install inside heating or air-conditioning systems;
• do not install inside pipes or in areas for fire prevention (such as ways out, elevators, tunnels, emergency
exits) since they have to ensure defined safety standards;
• Leave space around the product housing to allow ventilation. Excessive temperature and/or heat build-up
adversely affect the product life and could cause problems.
Safety and precautions: During the installation, follow the following instructions:
• never look inside the output of the splitter's optical connectors (the wavelength of the laser is not visible by
the eye; therefore, long-term damage is not immediately felt);
• when working with the splitter's optical connectors, make sure that the lasers of any optical transmitters
connected to it are switched off.
WARNING: Only authorized personnel can open the unit. Do not try to repair the unit; otherwise, the guarantee
will no longer be valid.
LASER RADIATION
DO NOT STARE INTO BEAM
OR VIEW DIRECTLY WITH
OPTICAL INSTRUMENTS

2. SAFETY WARNINGS

Danger symbols (according to EN 60825-1) for laser equipment.
WARNING! Laser radiation. Do not look inside the beam directly
or with optical instruments.

3. PRODUCT INSTALLATION

The following is contained in the packaging:
1 SIG7622 (SIG7624) optictal splitter
Fixing screws of the New Headline rack
The modules are installed using the 19" mounting rack for the Headline
range as shown in the following photos.
Insert the modules between the guides and push them back carefully
until they are in contact with the back panel. (see Fig. 2)
Fig. 2
6
Warning labels