Delta 32-325 Manual De Instrucciones página 15

LINE BORING
1. A typical line-boring operation is shown in Fig. 34.
Note that the right end of the workpiece is positioned
against the fence stop (A) and 13 holes are being
bored with a 32 mm center distance between each
hole.
2. If more than 13 holes are required, slide the work-
piece along the fence and push down on the
indexing pin (B) Fig. 35 until the pointed end of the
pin is in the last hole previously bored. This aligns
the workpiece for the next series of holes. Note
that the fence stop (A) has been pushed back
allowing the workpiece to fit flush against the
fence.
3. Bore the additional thirteen holes in the workpiece
(Fig. 36). All holes are 32 mm apart from each
other.
For assistance with your machine, visit our website at www�deltaportercable�com for a list of service centers or call the
DELTA Machinery help line at (800) 223-7278 (In Canada call (800) 463-3582).
TROUBLESHOOTING
15
A
B
A
Fig� 34
Fig� 35
Fig� 36