Cognex In-Sight Micro Serie Manual De Instrucciones página 3

Precautions
Observe these precautions when installing the vision system to reduce the risk of
injury or equipment damage:
An IEEE 802.3af compliant, and UL or NRTL listed, Power over Ethernet
l
(PoE) power source rated Class 0, 2, 3 or 4 must be used. Any other
voltage creates a risk of fire or shock and can damage the In-Sight vision
system components. Applicable local and national wiring standards and
rules must be followed.
To reduce the risk of damage or malfunction due to over-voltage, line noise,
l
electrostatic discharge (ESD), power surges, or other irregularities in the
power supply, route all cables and wires away from high-voltage power
sources.
Do not install In-Sight vision systems where they are directly exposed to
l
environmental hazards such as excessive heat, dust, moisture, humidity,
impact, vibration, corrosive substances, flammable substances, or static
electricity.
Do not expose the image sensor to laser light; image sensors can be
l
damaged by direct, or reflected, laser light. If your application requires the
use of laser light that may strike the image sensor, a lens filter at the
corresponding laser's wavelength is recommended. Contact your local
integrator or application engineer for suggestions.
The In-Sight vision system does not contain user-serviceable parts. Do not
l
make electrical or mechanical modifications to In-Sight vision system
components. Unauthorized modifications may void your warranty.
Changes or modifications not expressly approved by the party responsible
l
for regulatory compliance could void the user's authority to operate the
equipment.
2