Technical Data; Residual Risks - HERKULES DS 405/2 E Manual De Instrucciones

and safety at work.
The manufacturer will not be liable for any chan-
ges made to the machine nor for any damage
resulting from such changes.
Even when the equipment is used as prescribed
it is still impossible to eliminate certain residual
risk factors. The following hazards may arise in
connection with the machine's construction and
design:
•
Harmful emissions of wood dust when used
in closed rooms.
•
Contact with the blade in the uncovered cut-
ting zone.
•
Injuries (cuts) when changing the blade.
•
Crushed fingers.
•
Kickback.
•
Tilting of the workpiece due to inadequate
support.
•
Touching the blade.

4. Technical data

Mains voltage: ................................. 230 V ~ 50Hz
Power consumption: .................................... 80 W
Operating mode: ................................. S2 20 min
Power consumption: .................................. 120 W
Operating mode: .....................................S6 30%
Idle speed n : ................................400-1600 min
0
Protection type: ........................................... IP 20
Stroke: ...................................................... 21 mm
Base area: ..................................... 440 x 280 mm
Tilting range of table: .............. 0° to 45° to the left
Table size: ...................................... 410 x 253 mm
Saw blade length: ................................... 127 mm
Throat: .................................................... 406 mm
Max. cutting height at 90°: ......................... 57 mm
Max. cutting height at 45°: ........................ 27 mm
Weight: ........................................................13 kg
Load factor:
A load factor of S2 20 min (intermittent periodic
duty) means that you may operate the motor
continuously at its nominal power level (80 W) for
no longer than the time stipulated on the speci-
fi cations label (20 min). If you fail to observe this
time limit the motor will overheat. During the OFF
period the motor will cool again to its starting
temperature.
Anleitung_DS_405_2_E_SPK7.indb 16 Anleitung_DS_405_2_E_SPK7.indb 16
GB
Operating mode S6 30%: Continuous operation
with idling (cycle time 10 minutes). To ensure that
the motor does not become excessively hot, it
may only be operated for 30% of the cycle at the
specifi ed rating and must then be allowed to idle
for 70% of the cycle.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level:
pA
L sound power level:
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
-1
•
Wear protective gloves.

Residual risks

Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
- 16 -
Operation Idle speed
80.2 dB 65.1 dB
88.4 dB 74.8 dB
11.10.11 14:47 11.10.11 14:47