Vision TECHCONNECT tc2-ctl2 Manual Del Usuario página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 23
COPYING CODES TO MULTIPLE DEVICES
The codes from one Techconnect
1. Use a cable to connect the COPY terminals of the MASTER and SLAVE together as shown:
2. Press and hold LEARN button on the master until ONLY the GREEN LED on the REAR lights.
3. Press and hold LEARN button on the slave until the RED AND GREEN LEDs on the REAR both light.
4. Press any FUNCTION button on the front panel of the "master". The RED LED on the front panels of the
master AND slave modules will both flash and the codes will copy. This will normally take 10 seconds. When
finished the green LEDs of the master and slave units will flash three times simultaneously, then turn off.
The devices will automatically switch to "Normal Mode". If unsuccessful the red LEDs of the master and
slave modules will flash at the same time, then turn off. Try again.
Control
(master) can copied to other Control
2
2
modules (slaves).
2
(1) Red LED
(2) Green LED
7

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido