User Maintenance Instructions; Care & Cleaning Instructions - CHEF-BUILT CCT-500 Manual De Instrucciones

USER MAINTENANCE INSTRUCTIONS

This appliance requires little maintenance. It contains no user-serviceable parts. Any
servicing requiring disassembly other than cleaning must be performed by a qualified
appliance repair technician.
CARE & CLEANING INSTRUCTIONS
CAUTION: Do not immerse this Conveyor Toaster, cord, or plug in water or any other
liquid.
Switch this appliance to the OFF position, allow this appliance to cool completely and
unplug before cleaning.
This appliance cannot be cleaned by water jet.
Conveyor Belt: To remove baked-on food, make sure the Conveyor Toaster is clear of
all bread and food. Using a sponge or cloth, clean the belt using side to side motions
as the belt turns. Use a clean, slightly damp cloth to remove any loosened crumbs.
Toast Drawer: Lift up and pull out of the base of the unit. Clean the toast drawer with
warm detergent water. Rinse and dry thoroughly. Replace toast drawer by sliding back
onto the base. Make sure the front lip of the drawer rests flat onto the front of the
Toaster body.
Figure 2
Wire Bread Feeder: Insert left and right ends of the
feeder into holes located on each inside Toaster body
wall, above the conveyor belt. (See Figure2).
Reflector/Crumb Tray: The reflector/crumb tray is
located below the conveyor belt on the front of the
Conveyor Toaster. Pull the reflector/crumb tray out of
the front to remove. Clean the reflector/crumb tray
warm detergent water. Rinse and dry thoroughly. Push
clean reflector/crumb tray back into position. Make
sure crumb tray is inserted securely into the front of the
Conveyor Toaster.
Exterior: Wipe the Conveyor Toaster exterior with a clean, damp cloth. Do not use
abrasive cleaners. Do not put cord, or plug in water or other liquid.
8
SO-315014_18052_Chefbuilt_Conveyor toaster_CCT-500_Sensio_IM_R12.indd 8 2019-01-23 11:06 AM