Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS
Figure 1
Conveyor Toaster
1. Wire Bread Feeder
2. Conveyor Belt
3. Air Outlet
4. Darkness Control Knob
5. Power On/Off Switch
6. Power Saving Switch
7. Reflector/Crumb Tray
8. Toast Drawer
9. Power Cord (not shown)
BEFORE USING FOR THE FIRST TIME
1.
Remove all packaging materials including those that may be inside the toasting
chamber.
2.
Wipe the exterior with a damp cloth. Dry thoroughly. Do not use abrasive
cleaners. Do not place the Conveyor Toaster, cord or plug in water.
3.
Make sure the ON/OFF switch is in the OFF position
4.
Turn the DARKNESS control dial to LIGHT.
5.
Plug the Conveyor Toaster into a 120V AC electrical outlet
6.
Press the Power Saving Switch to FULL POWER / TOAST.
7.
Press the red ON/OFF switch to ON. The switch will illuminate.
8.
Allow the conveyor belt to revolve 2 or 3 times without bread. Let the toaster run
for about 15 minutes to burn off all the factory sediments.
NOTE: The Conveyor Toaster may emit a thin smoke on the initial use. This is
normal and not detrimental to the performance of the appliance.
INSTALLATION INSTRUCTIONS
CAUTION: To reduce the risk of fire, the appliance is to be installed in non-
combustible surroundings only, with no combustible material within 18 inches of
the sides, front, or rear of the appliance or within 40 inches above the appliance.
The appliance is to be mounted on floors of noncombustible construction with
noncombustible flooring and surface finish and with no combustible material against
the underside, or on noncombustible slabs or arches have no combustible material
against the underside. Such construction shall in all cases extend not less than 12
inches beyond the equipment on all sides.
SO-315014_18052_Chefbuilt_Conveyor toaster_CCT-500_Sensio_IM_R12.indd 6
1
2
7
8
6
3
4
5
6
9
2019-01-23 11:06 AM
Publicidad
Tabla de contenido
