Security Features; Control Panel Menu - Lincar Lola Manual Del Usuario

IT-GB-FR-ES mod. 540 – 540N

SECURITY FEATURES

The appliance is equipped with different security features, which grant and assure the regular
functioning.
-Pressure switch for the control of exhaust fumes. In case of obstruction of the fume
exhaust duct, due to materials, contrary wind, or to any other difficulty that do not allow a
regular outflow of the fumes, this device signals the problem to the appliance and a stop
cycle starts, while on the display appears "FAILURE DEPRESS".
-Mechanical security thermostat with manual resetting. This device is controlling the
temperature of the water of the boiler, in case a too high temperature (90°C...95°C) is
registered it stops immediately the feeding of fuel and a stop cycle starts, while on the display
appears "SAFETY THERMAL". The thermostat is placed on the lh back side, in order to
reset the thermostat unscrew the small protection cover and push on the pin of the thermostat.
-Boiler temperature control. The temperature of the boiler is constantly controlled by a
specific feeler in order to modulate the appliance during the normal working, in case the
temperature is exceeding the max. value (factory value setting) a stop cycle starts, while on
the display appears "HOT WATER".
-Fume temperature control. The temperature of the exhaust fumes is constantly controlled
by a specific feeler in order to control the regular working of the appliance, in case the
temperature is exceeding the max. value (factory value setting) a cooling cycle starts reducing
the power (FUME MODULAT) should the fume temperature continue to raise a stop cycle
starts, while on the display appears "HOT EXHAUST".
-Boiler pressure control. The pressure of the boiler is constantly controlled in order to verify
if it is within the limit values (min. and max), in case the pressure is not within the requested
values a stop cycle starts, while on the display appears "PRESS WATER".
-Fume expeller motor control. The fume expeller motor is constantly controlled in order to
verify its correct working, in case of anomaly a stop cycle starts, while on the display appears
"FAN LIGHTIN".
-Control of temperatures realising feelers. The regular working of the feelers, which
ensure a correct working of the appliance, are constantly controlled by the electronic card. If
the controlled values do not re-enter into the working parameters a stop cycle starts, while on
the display appears "FEELER EXHAUST" or "FEELER WATER".

CONTROL PANEL MENU

-Push on button P3 to have access to the menu
-Use buttons P5 and P6 to run on the different menu
-Push again on button P3 to enter into the displayed menu
-Use buttons P5 and P6 to run on the different submenu, the buttons P1 and P2 modify
the value shown on the display
-The button P3 accedes to the displayed menu/submenu
-The button P4 returns always to the previous menu
57/140