Installing The Batteries To The Remote; Connect Power & Antenna/Cable; Switching On/Off; First Time Installation - Dual 22970 Manual De Instrucciones

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
VGA
SPDIF

Switching On/Off

To Switch the TV On
• Connect the power cord to the 220-240V AC, 50
Hz socket.
• Switch the " " button on the rear left hand side
to position "|" so the TV will switch to standby mode.
Then the standby LED lights up.
To switch on the TV from standby mode either:
a. Press the " " button, CH ^ / v or a numeric button
on the remote control.
b. Press the middle of the "
By either method the TV will switch on.
Switching the TV Off
• Press the " " button on the remote control or press
the " " button, so the TV will switch to standby
mode.
• Switch the " " button to position 2 as illustrated,
so the TV will switch OFF.
Aerial or Cable
" button on the TV.
English - 34 -
To turn off the TV completely, remove the power
cord plug from the mains power socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such as
Standby Search, Over Air Download or Timer is active.
The LED can also blink when you switch on the TV from
standby mode.

First Time Installation

When turned on for the first time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the " " or "
required language, press OK button to select. "First
Time Installation" appears. Use "
set the required country, and press "
select Search Type (optional).
Use " " or " " to set the desired search type. Available
search types are Digital and analog, digital only and
analog only.
When set, press "
Use " " or " " to select the desired Teletext Language.
Next, select Scan Encrypted and set as Yes if you
want to scan coded stations.
Press OK button on the remote control to continue
and the following message will be displayed on the
screen.
" button to highlight the
" or " " button to
" button to
" to select Teletext Language.