Makita DLM431 Manual De Instrucciones página 10

Indicating the remaining battery
capacity
Only for battery cartridges with "B" at the end of the
model number
Fig.5: 1. Indicator lamps 2. Check button
Indicator lamps
Lighted Off
NOTE:
Switch action
WARNING:
Before installing the battery car-
tridge, always check to see that the switch lever
actuates properly and returns to the original posi-
tion when released. Operating a tool with a switch
NOTE:
switch button even the switch lever is pulled.
NOTE: Mower may not start due to the overload
when you try to mow long or dense grass at a time.
Increase the mowing height in this case.
Service Center.
1. Install the battery cartridges. Insert the lock key
into the interlock switch and then close the battery
cover.
Fig.6: 1. Battery cartridge 2. Lock key
2.
3.
Fig.7: 1. Switch button 2. Switch lever
-
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
may have
10 ENGLISH
4. Release the switch button as soon as the motor
release the switch lever.
5. Release the switch lever to stop the motor.
Adjusting the mowing height
WARNING:
Never put your hand or leg under
the mower body when adjusting the mowing
height.
WARNING:
Always make sure that the lever
between 20 mm - 75 mm.
1. Remove the lock key.
2.
mowing height.
Fig.8: 1.
NOTE:
the lawn or the ground, the actual lawn height may
NOTE:
ous place to get your desired height.
Grass level indicator
Fig.9: 1.
grass.
the basket, clean it so that its meshwork vents the
air.
NOTE:
may not work properly.
ASSEMBLY
WARNING:
Always be sure that the lock key
and battery cartridge are removed before carrying
out any work on the mower. Failure to remove the
lock key and the battery cartridge may result in seri-
WARNING:
Never start the mower unless it is
completely assembled.
partially assembled state may result in serious per-
-