Life Phases; Transport And Storage; Installation - RK Rose+Krieger 120 VA 230 V/115 V Instrucciones De Montaje

7.1 Transport and storage

Damage resulting from transport and storage is to be reported to the responsible manager and to
RK Rose+Krieger GmbH immediately.
The product is to be checked by qualified staff for visual and functional damage.
It is forbidden to put damaged controllers into operation.
The following environmental conditions have been specified for storing the controller:
•
contact with solvent-based paints must be avoided
•
lowest/highest ambient temperature: -25 °C/+60 °C
•
Relative humidity in storage: falling below the dew point is not permitted
Divergent environmental influences must be approved by RK Rose+Krieger GmbH.

7.2 Installation

The transformer controller must always be
fixed tightly or stand securely in order to
minimize risks to people and the environment.
The figure opposite shows the fixing plate that can be orde-
red as an accessory for the transformer controller.
The fixing plate can be mounted at a suitable location
on the base surface using 4 screws (see arrows).
The transformer controller is pushed onto the fixing plate
and locked in place.
7.2.1 Routing of electrical leads
When routing electrical leads, ensure that
•
these cannot become trapped,
•
no mechanical load is exerted on them,
•
they cannot become damaged in any other way, and
•
obstacles do not pose any risks to persons.

7. Life phases

25