Rear Panel Layout - VOX Amplification NIGHT TRAIN 50 Manual De Usuario

REAR PANEL LAYOUT
1
1. MAINS INPUT – Connect your electricity here with the supplied, detachable mains (power) cord.
2. 8 Ohm Speaker Jacks – This is used to connect the Night Train to any 8 ohm cabinet or 2 x 16ohm
cabinets.
3. 16 Ohm Speaker Jack – This is used to connect the Night Train to any 16 ohm cabinet.
WARNING ! Always use a non-screened VOX approved speaker lead with the Night Train
amplifier and cabinet.
WARNING ! Please ensure that your amplifier is connected to the correct mains power
voltage—please check the rear panel rating plate. If in doubt consult dealer.
WARNING ! NEVER operate this amplifier without the loudspeaker load being connected.
Serious damage can occur otherwise.
WARNING ! This amplifier must always be earthed (grounded) to prevent the risk of electrical
shock.
4. FX Loop Send – Connect this to the input of your effect.
5. FX Loop Return – Connect this to the output of your effect.
6. FX Loop Bypass – Press the button in to completely bypass the FX Loop.
7. Footswitch Jack – Connect the optional VFS2A footswitch here.
SPECIFICATIONS
Power Output:
Dimensions (W x H x D): 458 x 235 x 175 mm/18.03 x 9.25 x 6.89 inches
Weight:
Included items:
Options:
Specifications and appearance are subject to change without notice for improvement.
50 Watts RMS into 8 or 16 ohm
12.2 Kg/26.9 lbs.
Power cable, owner's manual, high quality speaker cable
VFS2A footswitch
7
2 3
4 5 6
7
www.voxamps.com