Brandt BCR160P Manual De Instrucciones página 7

DUAL ALARMS OPERATION
Before setting the alarm time, make sure the Clock has been set.
Setting Alarm 1 or Alarm 2
1. In clock time state, press AL. 1 / AL. 2 once and the display will
show the alarm time.
2. Press and hold AL. 1 / AL. 2 until the hour digits flash on the
display.
3. While the hour digits are flashing, set hours by repeatedly
pressing or pressing & holding
4. Press AL. 1 / AL. 2 to confirm.
• The minute digits will flash.
5. Whilst the minute digits are flashing, set minutes by repeatedly
pressing or pressing & holding
6. Press AL. 1 / AL. 2 to confirm.
• The display will show "1-5".
7. Whilst the weekday is flashing, set the alarm to sound on the
desired day(s) by repeatedly pressing or pressing & holding
.
1-5: all five weekdays
1-7: weekdays & weekends
6-7: weekends
1-1: one day of the week
• If 1-1 is selected, set the specific day by repeatedly pressing
/ .
8. Press AL. 1 / AL. 2 to confirm.
• "bu" will flash on the display.
9. Press AL. 1 / AL. 2 to confirm and the alarm will be set to wake
to buzzer.
• If you want to set the alarm to wake to radio, while "bu" is
flashing on the display, press
frequency. Press AL. 1 / AL. 2 to confirm. The volume level
will flash on the display.
• While the volume level is flashing, select the desired volume
level by repeatedly pressing
confirm.
10. The alarm will sound every day at the preset time for 30
minutes. To switch off the alarm press
/ .
/ .
/ to show the radio
/ . Press AL. 1 / AL. 2 to
.
EN-6
/