Technical Data - Battipav ProfiEVO Serie Manual De Instrucciones

Battipav srl

TECHNICAL DATA

Tool:
Intended use:
CERAMICS, SINGLE-FIRED TILES,
USE
CAUTION
Each machine is carefully checked before leaving
the factory.
BATTIPAV is constantly developing its machines,
and so reserves the right to make any changes
without notice. As a result, the information and
illustrations in this manual may differ from the
machine supplied.
The PROFI EVO tile cutter is a technologically
advanced, high performance machine that is suitable
for cutting ceramics, single-fired tiles and stoneware.
PRECAUTIONS
• The manufacturer accepts no responsibility
where the PROFI EVO tile cutter is used with
any tools other than those specified in the
"RECOMMENDED USE" paragraph.
ASSEMBLY
Proceed by assembling the PROFI EVO tile cutter.
The PROFI EVO IS ASSEMBLED AT THE FACTORY
FOR RIGHT-HANDED OPERATORS.
1 Position the cutter beam bracket and lock it into
place using the fastening knob.
LEFT HANDED OPERATORS
2
Using a 5mm male hexagonal wrench,
disassemble the "0 degrees" stop and place it in
the opposite housing (B) of the cutter beam
bracket's support.
3 Position the cutter beam bracket and block it
with the fastening knob.
TUNGSTEN CARBIDE WHEEL
Art. 2009
PORCELAIN STONEWARE
TRANSPORT
The PROFI EVO tile cutter can easily be transported.
• Remove the beam bracket from its seating.
4
• Position the cutting indicator and the relative
tile support plate on the inner side of the beam
bracket's arm.
4
• Using the screw hole positioned on the support
surface, fasten the upside-down cutter beam
bracket with the locking knob.
PERFORMING THE CUT
CAUTION
5 a) Lift the "0 degrees" register and position the
cutter beam bracket at an angle of "0 degrees";
6
b) Position the tile to be cut on the resting surface
at the cut point required.
For greater accuracy, use the cutting indicator
and the relative tile support plate;
7
c) raise the breaker foot;
d) Proceed by cutting into the glaze using the
8
cutting lever, exerting constant pressure
downward along the whole tile size;
9 e) Acting on the cutting lever, move the foot to the
break point then exert a gradually increasing
pressure until the tile is separated.
DIAGONAL CUT
• Loosen the beam bracket's locking knob;
10 • Move the supporting beam bracket to an angle
of 45° as shown in photo 8.
• Position the tile to be cut on the work surface
and proceed with cutting as described in the
"PERFORMING THE CUT" paragraph.
CAUTION
DIFFERENTLY SIZED DIAGONAL CUTS CAN BE
MADE BY USING THE CUTTING INDICATOR AND
THE TILE SUPPORT PLATE.
CAUTION
11
THE CUTTING BEAM BRACKET IS EQUIPPED
WITH A SPECIAL CENTIMETRE DIVISION FOR
DIRECTLY READING THE SIZE TO BE CUT.
CAUTION
12 USE THE SIDE EXTENSIONS FOR GREATER
STABILITY WHEN CUTTING LARGE-SIZED
TILES.
GB
11