Routine Maintenance - Battipav ProfiEVO Serie Manual De Instrucciones

GB

ROUTINE MAINTENANCE

REPLACEMENT OF CUTTING SPARE WHEEL
13
• Using a 3 mm hexagonal wrench, remove the
screw from its seat and the locking nut cutting
wheel.
14 • Remove the worn cutting wheel and replace it
with the supplied spare wheel.
Clean the surfaces from any residues.
For better smoothness of the cutting wheel,
it is recommended to lubricate the surface of
the locking screw with lithium grease.
Assemble again the screw and the locking
nut.
Always use original BATTIPAV spare parts
(Art. 2009).
CAUTION
15
• Adjust the cutting wheel by tightening the
screw with a 3 mm male hexagonal wrench,
until the lateral backlash is reduced, avoiding
any locking.
ADJUSTMENT OF CUTTING CARRIAGE
• Remove any residues from the slide bar of the
cutting carriage, without lubricating.
16
• Eliminate the lateral backlash of the carriage,
by acting on the screw indicated in picture 14,
using a 4 mm hexagonal head wrench.
CAUTION
AN EXCESSIVE ADJUSTMENT WILL DAMAGE THE
GOOD SLIDING OF THE CUTTING CARRIAGE.
12
DISPOSAL
In the event of scrapping the entire machine or part
of it, it must be disposed of in accordance with the
methods laid down by current legislation.
Worktable
Aluminium
Steel
Polyamide
Carriage rod
Steel
Aluminium
Polyamide
Battipav srl
Carriage
AL
AC
PA
AC
AL
PA