Maintenance; Filter Bag Cleaning; Filter Bag Removal And Replacement; Storage - Sears Craftsman CMXEVBE176780 Manual De Instrucciones

MAINTENANCE

Filter Bag Cleaning

WARNING:
!
To reduce the risk of injury from accidental starting,
unplug power cord before changing or cleaning filter.
Your Filter should be cleaned often to maintain peak Vac
performance.
After dirty Filter Bag removal from the Powerhead
Assembly, remove the dry debris by gently tapping Filter
against the inside wall of the disposal container.
NOTE: Clean the Filter Bag in an open area. Cleaning
should be done outdoors and not in the living quarters.
IMPORTANT: After cleaning, check the Filter Bag for tears
or small holes. Tears and holes in the Filter Bag can cause
debris and dust to be blown from the Vac. Do not use a Filter
Bag with holes or tears. Replace immediately.

Filter Bag Removal and Replacement

(Fig. P)
IMPORTANT: To avoid damage to the Blower Wheel and
Motor, always reinstall the Filter Bag before using the Vac for
dry material pick-up.
1. Extend the Retainer Band around the Plastic Posts on
the Powerhead Assembly.
2. Remove Filter Bag off the Filter Cage.
3. Place the replacement Filter Bag on the Filter Cage
until open end touches bottom of the Powerhead
Assembly.
4. Release the Retainer Band from the Plastic Post on the
Powerhead Assembly, holding the Filter Bag secure to
the Powerhead Assembly.
5. Make sure the Retainer Band is positioned on the Filter
Bag between the printed lines.
NOTE: See Repair Parts List for Part Number.
NOTE: Before installing the Filter Bag on the Vac, clean the
area of the Powerhead Assembly so that the Retainer Band
will seal the bag against the Powerhead Assembly and stop
small particles from bypassing the Filter Bag.
If the Filter Bag is clean and not damaged, replace it on the
Filter Cage. If it cannot be reused, place a new Filter Bag over
the Filter Cage.
SP7084-1 CMXEVBE176780.indb 13
Fig. P
Filter
Bag
Retainer Band
Lid
Powerhead
(upside-down)

Storage

Before storing your Vac, the Bucket should be emptied and
cleaned. The Power Cord should be wrapped around the
Carry Handle and the Hose should be stored as described in
this manual. Accessories should be kept in the same area as
the Vac so they can be readily available. The Vac should be
stored indoors.
Filter Bag
Rib Tab
Retainer Band
Lid
13
8/3/19 7:22 AM