Troubleshooting - JVC KD-LC333 Manual De Instrucciones

What appears to be trouble is not always serious. Check the following points before calling a service
centre.
Symptoms
• CD cannot be played back.
• CD sound is sometimes
interrupted.
• CD-R/CD-RW cannot be
played back.
• Tracks on the CD-R/CD-RW
cannot be skipped.
• "EJECT ERR" appears on the
display and CD cannot be
ejected.
• No message appears on the
display but CD cannot be
ejected.
• Sound cannot be heard from
the speakers.
• SSM (Strong-station
Sequential Memory)
automatic preset does not
work.
• Static noise while listening to
the radio.
• "NO DISC" appears on the
display.
• "RESET 8" appears on the
display.
• "RESET 1" – "RESET 7"
appears on the display.
• When "ERR 20" to "ERR 40"
appears on the display.
• This unit does not work at all.
• The CD changer does not
work at all.

TROUBLESHOOTING

Causes
CD is inserted upside down.
You are driving on rough roads.
CD is scratched.
Connections are incorrect.
CD-R/CD-RW is not finalized.
The CD player may function
incorrectly.
The volume level is set to the
minimum level.
Connections are incorrect.
Signals are too weak.
The antenna is not connected
firmly.
No CD is in the magazine.
This unit is not connected to a
CD changer correctly.
There is something blocking the
control cover movement.
The built-in microcomputer may
function incorrectly due to
noise, etc.
Remedies
Insert the CD correctly.
Stop CD play while driving on
rough roads.
Change the CD.
Check the cords and
connections.
• Insert a finalized CD-R/
CD-RW.
• Finalize the CD-R/CD-RW
with the component which
you used for recording.
Press and hold 4
more than 5 seconds.
¢, press the
While holding
reset button. Release the reset
button, then release
(Be careful not to drop the CD
when ejecting.)
Adjust it to the optimum level.
Check the cords and
connections.
Store stations manually.
Connect the antenna firmly.
Insert CD.
Connect this unit and the CD
changer correctly and press the
reset button of the CD changer.
Press the reset button of the
CD changer.
Press the reset button on the
front panel. (See page 2.)
If the reset button does not
works, check the Installation/
Connection Manual (separate
volume). (Ex.: You have used a
longer screws than specified.)
Press the reset button on the
front panel. (See page 2.)
for
¢.
29