cecotec Total Iron 8500 Implode Manual De Instrucciones página 24

ENGLISH
Turn the temperature dial to set the desired ironing temperature based on the garment to be
ironed. To activate the steam function, select the temperature range that steam is produced,
otherwise steam spray will not be emitted efficiently.
Temperature indicator
When the iron is heating up, the temperature indicator will turn on. Once the iron has reached
the selected temperature, it will turn off. The temperature indicator will switch on and off as
the iron maintains the selected temperature during ironing.
Lock button
Place the steam station on the heatproof stand of unit base, then push the lock button to
lock position in order to leave the iron in the base. To unlock it, push the lock button to unlock
position, then you can start ironing. The whole steam station can be lifted up by grasping the
iron' s handle, provided that the iron is not locked on the unit base (see Fig.4)
Fig.4
Steam trigger
After pressing the power switch and choosing the desired steam rate, it will indicate that the
device can be used when the steam rate indicator changes from flashing to steady. Then,
press the steam trigger gently so the steam will be sprayed from the soleplate continuously
(see Fig.5). When the steam trigger is completely loosened, the appliance can only be used for
dry ironing without steam.
Fig. 5
Shot of steam
Press the steam trigger twice within 1 second to activate the shot of steam function. Then you
can use the shot of steam to remove the toughest creases.
Refill indicator
When the level of water in the tank is low, the indicator will illuminate, followed by a buzzer
and the steam generator will stop working. When this happens, add water into the tank. For
this, remove the water tank and refill it with water through the filling aperture (see Fig.6),
then put the water tank back in its position.
Fig.6
Descaling indicator
If the descaling indicator light turns on, it means that the steam generator must be cleaned
of any mineral deposits. At this point, descale it following the steps on the "Cleaning and
maintenance" section. When the system ensures the mineral deposits have been removed,
the indicator will switch off.
Cord slot
24 TOTAL IRON 8500 IMPLODE / 9000 TURBO-BOOST
Total Iron 8500 Implode 9000 Turbo-Boost.indd 24 15/11/19 15:00