Preparing The Window - Haier HWR05XCM Guía De Uso Y Cuidado

PREPARING THE WINDOW

1. Measure the width of the window opening. (See Fig.14)
2. Mark the center line on the inside of the windowsill
with a pencil. (See Fig.15)
WIDTH OF
WINDOW OPENING
Fig. 14
WIDTH
NOTES AND WARNINGS:
• Be sure your air conditioner does not fall out of the window opening during installation
or removal.
• Do not block the air discharge or air intake areas on the front panel.
• Do not block the louvers on the outside of the air conditioner.
3. Center the air conditioner in the window sill.
Make sure to place the unit so that it is resting on the
windowsill with a ¼" to ½" downward tilt towards the
outside. Lower the window sash behind the top channel
to hold the unit in place. (See Fig.16)
NOTE: The appearance of your model may differ from the
one shown.
4. Loosen the screw located on the lower-right hand corner
of the air conditioner.
5. Slide the side bracket over the screw. The side bracket
should be resting on the window sill. (See Fig.17)
6. Partially tighten the screw. Secure the unit before tightening completely.
7. Use 1/8" drill bit to drill a starter hole through the holes in the side
bracket.
8. Using two (2) 1" wood screws, attach the side bracket to the
window sill.
9. Repeat for side bracket installation on the left-hand side of the air
conditioner.
PAGE 12
WIDTH
HOW TO INSTALL
CENTER LINE
Fig. 15
HEIGHT
WIDTH
Fig. 16
Fig. 17
CENTER