Control Panel - Linea Domo DO917GDK Manual De Instrucciones

MOVING YOUR APPLIANCE
· If the appliance is turned off for any reason, wait for 10 minutes before turning it back on.
This will allow the refrigeration system pressures to equalise before restarting.
· Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove
all mobile parts (shelves, accessories, etc.) or fix them into the fridge to avoid any shock.
IMPORTANT SAFEGUARDS
· Relocate and install. If the appliance has been left on its side for any length of time, leave it
Do not store food in beverage cooler, as interior temperature may not get cool
standing upright for at least 10 minutes.
enough to prevent spoilage. As a natural result of condensation, in summer
· Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an
months or area of high humidity, the glass door may built up moisture on the
environmentally friendly and natural gas, it is explosive. Therefore you should be careful
outside. Just wipe it away.
during shipment and installation to prevent your appliance's cooler elements from being
damaged. In the event of a leak caused by damage to the cooler elements, move your
fridge from open flame or heat sources and ventilate the room where the appliance is
OPERATING YOUR BEVERAGE COOLER
located for a few minutes.
It is recommended you install the beverage cooler in a place where the ambient
USE
temperature is between 22-25 degree Celsius .If the ambient temperature
in above or below the recommended temperature, conditions may cause the
· The refrigerator is only suitable for drinks and most definitely not for food.
interior temperature to fluctuate.
· When using the appliance for the first time, or using it after a period of non-activity, there
may be a discrepancy between the temperature displayed and the actual temperature. This
If the interior light is left on, the temperature inside the beverage cooler will be higher.
will correct itself after a few hours.
Recommended Temperatures for chilling beverage
· There is a minor temperature difference between the top and bottom in the refrigerator.
Because hot air rises, the upper shelves are somewhat warmer than the shelves at the
Sparkling wines
bottom of the refrigerator.
Cold beverage
SHELVES
The above temperatures may fluctuate depending on whether or not the interior
The shelves can be adjusted to the height of your bottles. The shelves can be raised or lowered
bulb is on or off or whether the bottles are located on the lower/middle or lower
by sliding them out of the refrigerator.
section.

CONTROL PANEL

1
1. Raising the temperature
2. Lowering the temperature
HOW TO USE THE BUTTONS ON THE DISPLAY PANEL:
You can set the temperature as you desire by pushing the button
3. Display
you push the two buttons for first time, the LED readout will show the original
4. Fahrenheit/Celsius indicator
temperature set at previous time (the temperature preset at the factory is 45 F)
.The temperature that you desire to set will increase 1 F or 1 C if you
5. Light on/off
push the
34
you push the
DO917GDK
7- C
-6 C
BEVERAGE
2
once, on the contray the temperature will decrease 1 F or 1 C if
once.
3 4 5
or . when