brennenstuhl Multi-Test MT 6 S/2 Instrucciones De Empleo página 9

013109 Multi-Test MT 6 S_2_013109 BA_Multi-Test MT 6_S 23.09.20
MT 6 S/2
Voltage Test (Alternating Current)
the test tip (1) contacts one of the poles of the socket
to be checked, the socket conducts voltage.
Note: as the presence of voltage at the socket is
measured by means of an antenna in the multi-tester,
the LED will flash upon contact with every single pole
of the socket and signal voltage.
Comment: With this testing method, we recommend
not contacting the screw (4) at the device in order not
to influence the measuring result.
start blinking. If there is a wire break, the LED display
will go out. This function can also be used to find alter-
nating current, e.g. in electrical outlets and plugs.
Notes:
1) To increase the sensitivity of the tester for
performing the touch-free voltage test, hold the
tester at the point of the probe.
2) The sensitivity can be reduced in high relative
humidity.
3) Perform the test at different points along the wire,
especially if the wire is twisted.
4) The test is not reliable on shielded wires.
Polarity test (direct current 3-36 VDC)
WARNING! Make sure that there is no alternating
current or high voltage current!
The LED will blink at the positive (+) pole.
The LED will not light up on the negative (-) pole.
Operating Instructions
(1) direct voltage test
(70-250 VAC)
ATTENTION!
The multi-tester is NOT a commer-
cially available phase tester.
If the LED (3) starts flashing when
(2) touch-free voltage test
(100-250 VAC)
Hold the tester as shown in the
picture and run it slowly along the
wire to be tested. If there is alternat-
ing current in the wire, the LED will
When testing, a finger of one hand
must touch the screw on the device.
At the same time, the tester's probe
must contact one pole of the
battery and your free hand must
touch the other.
9