Fault - Angelo Po 0G0BME Manual De Uso

CLEANING THE WELL
To carry out this operation, proceed as follows.
1 - Switch the appliance off and leave it to cool.
2 - Turn off the circuit-breaker to disconnect it from
the electrical mains.
3 - Apply a food-grade detergent to the inside of
the well.
CLEANING THE PANS
To carry out this operation, proceed as follows:
1 - Apply a food-approved detergent to the inside
of the pan.
2 - Rinse the pan with drinking water and drain.
The appliance has been tested before being
put into service. The information provided be-
low is intended to assist in the identification
and correction of any anomalies and malfunc-
tions which might occur during use. The user

Fault

IT
The heating elements do not
come on.
GB
DE
FR
ES
English
FAULT
TROUBLESHOOTING
Electrical connection not made
Safety thermostat tripped.
4 - Rinse the well with drinking water and
drain (see page 8).
5 - Apply a specific product or a water and vinegar
solution to the well to remove the detergent res-
idues.
6 - Rinse, empty and dry the well.
3 - Apply a specific product or a water and vinegar
solution to the pan to remove the detergent res-
idues.
4 - Rinse, empty and dry the pan.
can solve some of these problems himself, but for
others specific technical knowledge or skill is re-
quired, and so they must only be carried out by
qualified staff with recognised experience acquired
in the specific sector of operation.
Causes
correctly.
Switch faulty.
- 10 -
Remedies
Check the connection of the
electrical wires.
Replace the switch.
6