Electrical Connection; Testing Of The Appliance; Adjustments - Angelo Po 0G0BME Manual De Uso

ELECTRICAL CONNECTION

Important
The connection must be made by author-
ised, skilled personnel, in accordance with
the relevant legal requirements, using ap-
propriate and specified materials. The ap-
pliance is supplied with operating voltage
230V/1N.
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
Connect the appliance to the mains electricity sup-
ply as follows.
1 - If not already present, install a circuit-breaker
(A) with overload cutout and differential safety
breaker close to the appliance.
2 - Remove the control panel (B).
3 - Connect the automatic circuit-breaker (A) to the
terminal board (C) of the appliance as shown in
the diagram and in the electrical system dia-

TESTING OF THE APPLIANCE

Important
Before it is put into service, the system
must be tested to check the operating con-
ditions of every single component and
identify any malfunctions. In this stage, it is
important to check that all health and safety
requirements have been complied with in
full.
To test the system, make the following checks:
The appliance's main functions do not require any
special adjustments by specialist staff except the
settings made during use by the user.
When connecting, take care to connect
the neutral and earth lines.
After testing, if necessary instruct the user in all the
skills necessary for putting the appliance into oper-
ation in conditions of safety, in accordance with le-
gal requirements.

ADJUSTMENTS

- 13 -
A
B
gram at the back of the manual.
N.B.: use a cable with at least H05RN-F characteristics.
Important
4 - Replace the control panel (B) on comple-
tion of the operation.
1 - check that the mains voltage is the same as that
of the appliance;
2 - operate the appliance's circuit-breaker to check
the electrical connection;
3 - check that the safety device is operating cor-
rectly.
C
IDM-39603604600.tif
IT
GB
DE
FR
ES
8
English