Suunto S6 Guia Del Usuario página 25

3. Change the field to either on or off with the arrow buttons and press Suunto.
The icons are now set.
Setting the light
Light is the backlight of the Suunto S6 display. It has three possible settings:
• Normal: The light switches on when you press Start for more than 2 seconds.
The light is on for 5 seconds after the last press of a button.
• Off: The light does not switch on from any button or during an alarm.
• Night Use: The light switches on when you press a button and stays on for
5 seconds after the last press of a button.
NOTE: The backlight goes on when an alarm sounds in Normal and Night Use.
To change the light settings:
1. In the Function menu, scroll to General and press Suunto. The General menu is
displayed.
2. Scroll to Light and press Suunto. The current light setting is displayed in reversed
color.
3. Select the suitable light setting with the arrow buttons and press Suunto. The light
setting is set and you return to the function menu.
Calibrating the air pressure sensor
The pressure sensor of the Suunto S6 is accurately calibrated when the product
leaves the factory. However, the calibration can slightly shift over time. You can
adjust the calibration offset but you should only do it if you notice that the current air
pressure shown on the bottom row in the Weather mode differs from a reference
value of the barometric pressure measured with a certificated high-accuracy ba-
rometer. You can set the value by 0,1 hPa or 0,01 inHg steps. The reference value
23