General EMR813 Manual Del Usuario página 4

• When replacing batteries for the home receiver,
please remove batteries of all remote sensors and
re-install the batteries to the sensors according to
the desired channel sequence.
• Press the Tx button on the back of remote sensor
to verify the RF reception, hold the button 3 sec to
reset.
°F/°C SELECTION:
In normal mode, press " - " button to select F and C.
MAX/MIN MEMORY:
Press the "MAX/MIN" to view the maximum values
for 5 seconds, press again to view the minimum
memory. To clear the memory record, press "CLEAR"
while the respective values displaying on screen.
TEMPERATURE ALERT:
• Press "ALERT" to turn temperature alert on and off.
• Hold "ALERT" 3 seconds to enter the alert setting
mode. The remote channel and the Upper + Lower
pointers flash. (if more than 1 remote sensor is
registered, press Ch to select channel & press
ALERT to confirm)