Technical Data - GÖLZ FT 200 Manual De Instrucciones

GB

Technical data

Voltage:
Power absorbed:
Admissible working conditions:
INTERMITTENT - S3-SERVICE
Rotation speed:
Capacitor:
IP Degree:
Thermal circuit breaker:
Tool:
CONTINUOUS CROWN DIAMOND BLADE
Diameter:
Centre hole:
Max. cutting depth:
40 mm - cut 90° / 40 mm cut 45°
Water recirculation pump:
Recommended use:
CERAMIC, SINGLE-FIRED CERAMIC, COTTO
AND MARBLE (max. thickness 20 mm.)
Weight:
Max. cut length:
Tank capacity:
1. Use
CAUTION !
Before using the machine read the safety
instruction chapter carefully.
All machines have been thoroughly tested and
checked before leaving our factory.
GÖLZ works for a continuous development of
the machines the company manufactures,
therefore the company reserves the right to
modify its models.
230V 50Hz~
1000W
30 sec. under load running
30 sec. rest
2800 min
18 µF
170°C
WET CUTTING
Ø200 mm
25,4 mm
S0 230V 50/60Hz
34 Kg
600 mm
No rights can be therefore claimed as far as data
and pictures of this manual are concerned.
The FT200 diamond blade cutting machine is
suitable for cutting any type of ceramic material. It
can also be used to carry out 90° as well as 45° cuts
(jolly). The cutting depth and inclination can both be
adjusted.
2. Precautions
-1
• The manufacturer declines any liability for the
use of any FT200 tile cutter with tools other than
the original ones and for the cutting of materials
44
not indicated
"RECOMMENDED USE".
• The FT200 is designed to work exclusively
according to the ADMISSIBLE WORKING
CONDITIONS indicated in the paragraph:
"TECHNICAL DATA".
• During the cutting phase it is therefore
recommended to interrupt the working cycle as
indicated.
• The FT200 was not designed to work under
continuous load.
CAUTION !
Keep in mind the following tips:
• Let the motor slide slowly. Avoid any disk
blocking.
• Make sure that the piece to be cut is duly
leaned against the tile stopper.
• Before any cutting operation make sure that
the adjustment knobs for cutting inclination
are tightened.
• After some cutting sharpen the disk with a hone.
25 L
CAUTION !
DO NOT USE DIAMOND TIPPED DISCS OF
DETERIORATING QUALITY OR THAT ARE NOT
SUITABLE FOR THE SPECIFIC USE FOR WHICH THE
MANUFACTUERE SUPPLIED THEM.
USE OF DETERIORATING DISCS CAN HARM THE
OPERATOR AND DAMAGE THE MACHINE, AS WELL
AS SIGNIFICANTLY SLOWING THE WORK.
18
in the paragraph