Wagan Tech 8576-2 Manual De Usuario página 10

Solar + LED Floodlight 1000 by Wagan Tech
When the timer is over, it will reset to the default M1 motion detection mode and
repeat this program (Timer + M1) the following night, until another program is
selected.
To cancel the Timer mode, long press one of the T2, T3 or T4 buttons for 2
seconds. The indicator LED's on the light will flash 3 times.
MEMORY
The light will remember the last button/program pressed and revert to that setting
the following nights until a new program is set.
Examples:
• If you choose 60% (no timer) the first night and do not change it, it will keep
60% the next night. But if the battery is low, it will default to M1.
• If the light is set to 60% brightness for 4 hours on night 1, it will change to
M1 mode at the end of the 4 hours. On night 2, it will run the program for
60% brightness for 4 hours and then M1. This pattern will continue until
another button is pressed.
• If the battery drains during timer mode, the light will turn off but will keep
the same lighting mode the next night once the battery is recharged.
9
Red LED indicators
www.wagan.com
®