Motion Detection - Wagan Tech 8576-2 Manual De Usuario

Solar + LED Floodlight 1000 by Wagan Tech
There are 3 main modes the light can be operated in:
Motion Detection, Brightness Override and Timer mode.

Motion Detection

• M1 (default mode): Steady on at 10% brightness and then 100% brightness
when motion is detected by the PIR sensor. 30 seconds after motion ceases,
the light returns to 10% brightness.
• M2: Steady on at 30% brightness and then 100% brightness when motion
is detected by the PIR sensor. 30 seconds after motion ceases, the light
returns to 30% brightness.
Brightness Override
A constant brightness can be selected by pressing one of the four brightness
buttons on the remote. This will override the motion detection modes (M1 or M2).
• 10% - 100 lumens
• 30% - 300 lumens
• 60% - 600 lumens
• 100% - 1000 lumens
The light will remain at the set brightness until dawn, the end of the timer mode
(see next section) or until battery is low. If the battery is too low during the night
7
www.wagan.com
®