Perel DDPH2 Manual Del Usuario página 4

5. Overview
Refer to the drawing on page 2 of this manual.
# Description
1 Centre leg
2 Outer leg
3 Caster (with brake)
4 Sliding yoke
5 Positioning arm
6 Backstop
7 Main vertical frame
8 Telescopic section – inner part
9 Telescopic section – outer part
10 Winch assembly
11 Slide bar
12 Slide bar lock
13 Steel cable
6. Assembly
The drywall lift is composed of 3 main parts:
Tripod base assembly
o
Vertical frame assembly
o
Cradle assembly
o
Tripod base
 Mount the casters [3] in the tripod base.
 Place the base on its casters [3] and lower the backstop [6].
 Press and hold the ring of the yoke [4] down while unfolding the two outer legs [2], until the
yoke pin snaps into the locking hole near the centre of the tripod.
Vertical frame
 Install the vertical frame [7] in the V-shaped angles on the tripod base. Make sure the frame is
pushed all the way down.
 Attach the handle [19] to the winch wheel [16].
 Move the winch assembly [10] into working position by holding the wheel [16] and brake
handle [18] as shown in figure 2. Push the brake handle all the way up while rotating the wheel
slightly forward, grab the winch arm and secure the brake handle with your thumb to prevent
backlash (figure 3).
00 (11/12/2012)
DDPH2
Figure 1
Figure 2
# Description
14 Pulley
15 Retaining hook
16 Winch wheel
17 Winding drum and brake assembly
18 Brake lever with spring
19 Winch wheel handle
20 Load cradle
21 Extendable arm with protective caps
22 Extendable arm pin lock
23 Cradle mounting head with tilt latch
24 Crossbar with protective caps
25 Hook for panel support
Figure 3
4