T R O U B LE S HO O T I NG
Troubleshooting
IC E P R O DUCT I O N
No ice.
•
Verify
or
appears in the freezer external display.
•
Verify the ice maker has been on for at least 24 hours.
•
Verify the freezer temperature is near 0°F.
•
Verify the ice container is properly installed.
•
Verify the ice maker arm in the down position.
•
Verify water is being supplied to the unit.
•
Verify the water filter has been replaced within the last 12
months and installed properly.
•
Verify the water filter has been removed if a reverse
osmosis filtration system is being used.
Blue or green ice.
•
Possible copper supply line corrosion. Contact a
plumber to clean or replace.
Black flecks in the cubes.
•
Stop use and contact Sub-Zero Factory Certified
Service.
Bad taste.
•
Defrost the freezer and clean with soap and water.
•
Place coffee grounds or charcoal briquettes in the
freezer to absorb odor.
Hollow cubes.
•
Clean the condenser. Contact Sub-Zero Factory Certified
Service if unresolved.
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &
Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
14 | Sub-Zero Customer Care 800.222.7820
SERVI C E
•
Maintain the quality built into your product by contacting
Sub-Zero Factory Certified Service. For the name of the
nearest Sub-Zero Factory Certified Service, check the
Support & Service section of our website, subzero.com,
or call Sub-Zero Customer Care at 800-222-7820.
•
When contacting service, you will need the model and
serial number of your unit. Both numbers are listed on
the product rating plate. Refer to page 4 for rating plate
location.
•
For warranty purposes, you will also need the date
of installation and name of your authorized Sub-Zero
dealer. This information should be recorded on page 2.