Displaying Stored Results; Deleting Memory - ProMed MTX Instrucciones De Manejo

GB
5 Memory
5.1 Recording the results
This unit features 2 separate memories, each with a capacity of 99 memory slots.
Results are automatically stored in the memory selected by the user.
When the memory is full, the oldest reading is always the first to be deleted.

5.2 Displaying stored results

Press the MEMO button to display the stored readings. After all the segments in the
display have been shown, an average value of all the measurements in the selected
memory is displayed. This average is indicated by " ". When the MEMO button is
pressed again, the individual readings (switching between systolic, diastolic, pulse and
date/time) of the last measurement stored are displayed. If this measurement was
taken in the 3MAM procedure, is displayed. If an arrhythmia was detected during
the measuring process, the arrhythmia symbol will be displayed, but not flashing.
Press the MEMO button again to move backwards through the stored readings.
If you do not press any buttons for approx. 1 minute, the device automatically
switches back to standby mode.
5.3 Deleting a measurement
Select the entry for the measurement you want to delete. Press and hold the START
button for approx. 10 seconds until the memory symbol flashes. Confirm your
deletion request by pressing the MEMO button. " " appears briefly on the display
and 2 short beeps sound. The entry you selected has been deleted. The display returns
to standby mode.

5.4 Deleting memory

The data can be deleted from the memory selected by pressing and holding the
MEMO button for about 7 seconds. After 7 seconds, the display shows " "
( CLEAR ) which indicates that all data will be deleted.
Confirm your deletion request by pressing the MEMO button again. Three short beeps
sound during the procedure.
36